The sandwich pot temperature control system of the heat transfer oil sandwich pot manufacturer can effectively save electricity

The sandwich pot of the heat-conducting oil sandwich pot manufacturer has an automatic temperature control system. This temperature control system can effectively save electricity, and the parameters of the halogen-cooked sandwich pot. After the electric heating sandwich pot is energized, it is only necessary to set the required temperature. After the oil-sandwich pot is automatically heated to the set temperature, the temperature is automatically stopped, and the heat is maintained. When the temperature of the sandwich pot is lower than the set temperature by 2 degrees, the heating system is turned on again. Let the user's every use of electricity be worth the money.

Heat transfer oil sandwich pot manufacturers advantage:

(1), full combustion, smokeless and dust-free, a small amount of carbon deposits, no environmental pollution.

(2) The flame temperature is adjusted at will, and the temperature zui is as high as about 300 °C.

(3) The structure is reasonable and the operation is convenient.

(4), strong energy-saving, fierce fire, thermal efficiency increased by about 25% compared with similar products.

(5) Fuel: Liquefied petroleum gas, pipeline gas, natural gas, oil is strictly prohibited.

(6), gas consumption: about 20% lower than similar products.

Installation and commissioning of the sandwich pot of the heat transfer oil sandwich pot manufacturer:

1. When unpacking, check whether the product and the accessory are consistent with the packing list. If the product and parts are damaged during transportation, if there is any loss or damage, please solve it with the company in time.

2. The product has been tested before leaving the factory. The relative positions of all components have been installed and adjusted. The user generally only checks and does not disassemble it at will, so as to avoid improper installation and adjustment, which affects the product performance.

3, the heat transfer oil sandwich pot does not need to be fixed, as long as it is placed on a flat concrete floor.

4. The power supply should meet the requirements of the agitating structure of the equipment. The equipment casing must have a good grounding to avoid accidents caused by leakage.

5. When installing the sandwich pot of the heat transfer oil sandwich pot manufacturer, care should be taken to ensure that the oil inlet pipe is unblocked and there is no obstruction.