Electric heating sandwich pot operation instructions

(1) One R3/4" x 90 outer wire head and 3/4 wire type ball valve at the right rear 45° of the outer arc of the outer arc for exhausting. The exhaust device is at the high end of the jacket, which is beneficial to The discharge of gas during the heating of the heat transfer oil prevents the heat transfer oil from splashing out during heating.

(2) 200L electric heating sandwich pot When adding L-QC320 type heat transfer oil 38kg (quantity is for reference only), first put the pot flat, fix the pot body with the locking device, and then put the exhaust ball valve and the oil into the oil The pot device is connected and used, and the oil measuring hole is opened for exhausting. It is necessary to observe the oil measuring hole and put the pan flat heat transfer oil to overflow the hole. The hole is also a normal heat conduction oil observation hole. When the heat transfer oil is less than this limit Please raise when you are in position.

(3) When the heat transfer oil starts to heat, remove the oil inlet pot device and open the exhaust ball valve. After the heating is completed, close the exhaust ball valve, and shake the handle to turn the pot and turn the material. Use the oil inlet pot device as an accessory. When refueling, connect the fueling device to the exhaust ball valve and remove it after refueling.

(4) After electrically heating the sandwich pot, PT10 is used to measure the temperature of the heat transfer oil, and the set temperature is detected by the electric control box. When the set temperature is exceeded, the heating will not be continued. Otherwise, when the temperature is lower than the set temperature Will continue to heat up.

(5) Install the 3/4 ball valve (300 °C high temperature resistance) at the bottom oil draining device. When the oil is required to be drained, the ball valve can be opened, which makes the oil draining more convenient.

2. Brush the hot sandwich pot and put in the material. Inject the heat transfer oil first, turn on the power supply, and turn off the power when the material reaches the required temperature and the predetermined heating time. The hand wheel can be turned to tilt the pot and discharge. At this point, the job is completed.

3. For each operation, check the capacity of the heat transfer oil to avoid dry burning and damage to the equipment.

4. To ensure the cleanness of the heat transfer oil, it should be replaced every 3 months.

5. To keep it clean, it should be cleaned once every time it is used.

6. The tilting type pot should check the lubrication of the rotating part before use. The oil cup should be filled with grease and the worm and worm bite should be filled with appropriate amount of grease.